Olivetti d-Color MF4003 User Manual

d-Color MF4003/MF3303
J BILLING SETTING/ENHANCED SECURITY/DEBUG SETTINGS > 2. ENHANCED
SECURITY
J-24
NOTE
▪ To reflect the adjustment value after change, make sure to exit from the Service Mode.
▪ The adjustment value is not reflected when turning off the power without exiting from the Service Mode.
(14)Choice 1 of extending PU life
To change the imaging unit life threshold.
Switch No.33 Contents Default
OFF To use the default threshold.
○
ON To use the threshold 1.25 times the normal one.
(15)Choice 2 of extending PU life
To change the imaging unit life threshold.
Switch No.34 Contents Default
OFF To use the default threshold.
○
ON To use the threshold 1.5 times the normal one.
(16)Choice of improving fusibility strength
• Choice to raise fusing temperature to secure fusibility for the image erasing problem with eraser test
Switch No. 35 Contents Default
OFF -
○
ON Raise the fusing temperature.
(17)Choice of silent mode
• Switches the drive for the polygon motor, fusing, and fan during standby.
Switch No.37 Contents Default
OFF Normal mode
○
ON Silent mode Level (highest-speed rotation before printing/after printing is not energized)
(18)Choice of disabling engine log via CTL
• Choice to disable an engine log via CTL
Switch No.39 Contents Default
OFF To enable an engine log via CNT.
○
ON To disable an engine log via CNT. (Terminal output)
NOTE
▪ To reflect the adjustment value after change, make sure to exit from the Service Mode.
▪ The adjustment value is not reflected when turning off the power without exiting from the Service Mode.
(19)Choice of increasing registration stabilization frequency
• Choice of increasing registration stabilization frequency by PH temperature change
Switch No.42 Contents Default
OFF Disable
○
ON Enable
(20)Choice of HH memory upper limit voltage
• Release protection against upper limit voltage of 1st transfer
Switch No.43 Contents Default
OFF With protection against upper limit voltage of 1st transfer
○
ON No protection against upper limit voltage of 1st transfer
(21)Choice of UFP behavior mode
• Choice to conduct a control to restrict the occurrence of UFP
Switch No.46 Contents Default
OFF Not to conduct a control to restrict the occurrence of UFP.
○ (Except for
Europe)
ON Not to conduct a control to restrict the occurrence of UFP.
○ (Europe only)
NOTE
▪ To reflect the adjustment value after change, make sure to exit from the Service Mode.
▪ The adjustment value is not reflected when turning off the power without exiting from the Service Mode.
Service Manual
Y119930-3

Olivetti d-Color MF4003 Specifications

General

Brand	Olivetti
Model	d-Color MF4003
Category	Copier
Language	English