d-Color MF4003/MF3303
I SERVICE MODE > 8. CS Remote
I-22
Setting item Contents
[2] Error count data
[3] Service count data
[4] Life count data, Life cycle data
[5] CSRC-System data, Device config data
[6] History data
[7] EKC data
[8] Adjustment data
[9] Coverage data
[10] Not used
[11] Not used
[12] Not used
NOTE
▪ Multiple items of data can be selected and sent at one time. However, be sure that only EKC data cannot be sent together
with other items of data.
Center/Device ID
• It will be displayed when or “http1,” “http2,” “Modem” or “Fax” is selected in System Setting.
Setting item Contents Setting value Default setting
Center ID Set the center ID.
When all setup procedures are completed, the center ID is displayed.
5-digit
alphanumeric
characters
00000
Device ID Display the device ID.
It can only be displayed but not be changed.
13-digit
alphanumeric
characters
-
Client Settings
• It will be displayed when “http1” or “http2” is selected in System Setting.
• To set whether or not to encrypt communication.
• When all setup procedures are completed, the details of setting is displayed.
Setting value Default setting
Yes
○
No
Heart Beat
• It will be displayed when “http1” is selected in System Setting.
• To make Heart Beat related settings.
• Heart Beat is a feature that uploads a Heart Beat file to the registered web server at a specified interval to report that the device is
operating. Heart Beat files include total counter and status information.
Setting item Contents Setting value Default setting
Communication To set whether or not to enable Heart Beat communication. Yes
○
No
Comm. Interval Set the communication interval to enable Heart Beat communication. 1 to 256 (minutes) 30 (minutes)
Specified
Transmission
To set whether or not to enable Heart Beat transmission at a specified interval. Yes
○
No
Polling Interval
• It will be displayed when “http1” is selected in System Setting.
• To set the polling time in http communication.
Setting range Default setting
1 to 256 (minutes) 5 (minutes)
Center Telephone Number, Device Telephone Number
• It will be displayed when “Modem” or “Fax” is selected in System Setting.
• Set the telephone number of the Center.
• Set the telephone number of the Device.
NOTE
▪ When entering the telephone number, 10-key and keys on the screen have following meanings.
Keys Contents
[-] Pose Waits to start transmitting after dialing
[W] Wait Detects the dial tone of the other end
[T] Tone dial Carry out tone dialing
[P] Pulse dial Carry out pulse dialing
[*], [#] To be used as necessary
To Next Page
Loading...
Need help?
General