Uncorrected error recovery interrupt enable. When enabled, the error recovery interrupt is
generated for all detected Uncorrected errors that are not deferred. The possible values are:
0 Error recovery interrupt disabled.
1 Error recovery interrupt enabled.
Note
Applies to both reads and writes.
RES0, [1]
RES0 Reserved.
ED, [0]
Error Detection and correction enable. The possible values are:
0 Error detection and correction disabled.
1 Error detection and correction enabled.
Configurations
This register is accessible from the following registers when ERRSELR.SEL==0:
B2.39 ERXCTLR_EL1, Selected Error Record Control Register, EL1 on page B2-199.
B3 Error system registers
B3.3 ERR0CTLR, Error Record Control Register
100798_0300_00_en Copyright © 2016–2018 Arm Limited or its affiliates. All rights
reserved.
B3-295
Non-Confidential