Date Code 20151029 Protection Manual SEL-411L Relay
Section 5
P.Protection Manual
Settings
Overview
This section contains tables of relay settings for the relay that have not been
described in other sections.
The relay hides some settings based upon the state of other settings. For
example, if you set an enable setting to OFF (disabling the function), then the
relay hides all settings associated with that function.
The settings prompts in this section are similar to the ASCII terminal and
ACSELERATOR QuickSet
®
SEL-5030 Software prompts. The prompts in this
section are unabbreviated and show all possible setting options.
The section arranges settings in the following order.
➤ Alias Settings on page P.5.2
➤ Global Settings on page P.5.4
➢ General Global settings
➢ Global enables
➢ DC monitors
➢ Control inputs
Table 5.1 Setting Categories and Appropriate Section
Settings Category Section
Alias (SET T) Section 5: Settings
Automation (SET A) Section 14: SEL
OGIC Control Equation Programming
DNP (SET D) Section 4: DNP3 Communications in the Communications Manual
Front-Panel (SET F) Section 7: Front-Panel Operations
Global (SET G) Section 5: Settings
Group (SET) Section 3: Protection Functions
Logic (Protection) (SET L) Section 5: Settings / Section 14: SEL
OGIC Control Equation Programming
MIMIC (Bay Control) (SET B) Section 12: Bay Control
Monitor (SET M) Section 9: Monitoring and Metering
Notes (SET N) Section 15: ASCII Command Reference
Output (SET O) Section 15: ASCII Command Reference
Port (SET Pn) Section 5: Settings / Section 9: Monitoring and Metering / Section 6: Synchrophasors in the Com-
munications Manual / Section 1: Communications Interfaces in the Communications Manual /
Section 2: SEL Communications Protocols in the Communications Manual / Section 4: DNP3
Communications in the Communications Manual / Section 13: Time-Synchronized Measurements
Report (SET R) Section 8: Oscillography, Events, and SER
To Next Page
Loading...
