Sel 411L - Table 15.168 VIEW 1 Commands-Region; Table 15.169 VIEW 1 Commands-Register Item

P.15.64
SEL-411L Relay Protection Manual Date Code 20151029
ASCII Command Reference
Description of Commands
If an item is not installed, the VER report indicates Not installed at the
appropriate line. If a detected hardware configuration does not match the
component part number, the relay adds the statement
Warning - hardware
does not match part number
on the corresponding line.
VIEW
Use the VIEW command to examine data within the relay database. You can
view these data in three ways:
➤ Region
➤ Register item
➤ Bit
The VIEW command in the relay is very similar to the VIEW command in
SEL Communications Processors. See Section 1: Communications Interfaces
in the Communications Manual for more information on the relay database
regions and data types.
Relay regions are LOCAL, METER, DEMAND, TARGET, HISTORY,
BREAKER, STATUS, and ANALOGS; view this list with the MAP 1 command.
The relay is Virtual Device 1; all commands begin VIEW 1. In all database
views, if a data item is in test mode, the relay displays an asterisk (*) mark
following the data value.
VIEW 1 Commands—Region
Use the commands in Table 15.168 to view the contents of the database regions.
VIEW 1 Commands—Register Item
Use the commands in Table 15.169 to view register items in the relay
database. Examples of register items in the METER region are IA1, I0_1, VB,
and PF. Examples of register items in the LOCAL region are FID,
SER_NUM, and PART_NUM.
Table 15.168 VIEW 1 Commands—Region
Command Description Access Level
VIEW 1 region Display the data in the relay database in the
region region.
1, B, P, A, O, 2
VIEW 1 region BL Display the data in the region region and include
bit labels.
1, B, P, A, O, 2
Table 15.169 VIEW 1 Commands—Register Item (Sheet 1 of 2)
Command
a
Description Access Level
VIEW 1 addr Display the data in the relay database at register
address addr.
1, B, P, A, O, 2
VIEW 1 addr NR
m
Display the data beginning at register address addr
and continue for m registers.
1, B, P, A, O, 2
VIEW 1 region
item_label
Display the data for the addresses in the region
item_label area of the database.
1, B, P, A, O, 2
VIEW 1 region
item_label NR m
Display the data for addresses in the region
item_label area of the database; begin at the start
of item_label and proceed for m registers.
1, B, P, A, O, 2