Sel 411L - Table 15.128 SHO Command Overview; Table 15.129 SHO a Command; Table 15.130 SHO B Command

P.15.50
SEL-411L Relay Protection Manual Date Code 20151029
ASCII Command Reference
Description of Commands
terminal and you specify a setting in the middle of a settings category, the
relay displays the category title, then proceeds with the class or instance
settings from the setting that you specified.
SHO
The SHO command with no options or parameters accesses the relay settings
Group class and the instance corresponding to the active group. To show a
different instance, specify the instance number (1–6).
SHO A
Use the SHO A command to show the Automation SELOGIC control
equations. See Section 14: SEL
OGIC Control Equation Programming for more
information on SEL
OGIC control equations.
SHO B
Use the SHO B command to show the Bay Control settings in the relay. There
is only one instance for the Bay Control settings. See Section 12: Bay Control
for more information on Bay Control settings.
SHO D
The SHO D command shows the DNP3 remapping settings. To view the
general serial port DNP3 settings, use the Port settings. There are five
instances of the DNP3 remapping settings. For more information, see
Section 4: DNP3 Communications in the Communications Manual.
Ta b l e 1 5.1 28 S H O Co m m a n d O v e r v i ew
Command
a
a
Parameter n = 1–6, representing Group 1–6.
Description Access Level
SHO Show the Group relay settings, beginning at
the first setting in the active group.
1, B, P, A, O, 2
SHO n Show the Group n relay settings, beginning at
the first setting in each instance.
1, B, P, A, O, 2
SHO label Show the Group relay settings, beginning at
the active group settings label label.
1, B, P, A, O, 2
SHO n label Show the Group n relay settings, beginning at
the settings label label.
1, B, P, A, O, 2
Table 15.129 SHO A Command
Command
a
a
Parameter n = 1–10 for Block 1–10.
Description Access Level
SHO A Show the Automation SELOGIC control
equation relay settings in Block 1.
1, B, P, A, O, 2
SHO A n Show the Automation SEL
OGIC control
equation relay settings in Block n.
1, B, P, A, O, 2
Ta b l e 1 5.1 30 SH O B C o mm a n d
Command Description Access Level
SHO B Show the Bay Control relay settings, beginning
at the first setting in this class.
1, B, P, A, O, 2
SHO B label Show the Bay Control relay settings, beginning
at settings label label.
1, B, P, A, O, 2
NOTE: This does not display
mapping information for DNP
LAN/WAN.