P.5.19
Date Code 20151029 Protection Manual SEL-411L Relay
Settings
Port Settings
Make Table 5.37 settings if preceding setting PROTO RTD.
Make Table 5.38 settings if Port setting PROTO := SEL, DNP, or PMU.
Make Table 5.40 settings if Port setting PROTO := DNP.
Table 5.37 Communications Settings
Label Prompt Default Value
MBT Using Pulsar 9600 modem? (Y, N) N
SPEED
a
a
For PROTO := MBA or MBB, 57600 not available.
Data Speed (300, 600, 1200, 2400, 4800, 9600, 19200,
38400, 57600, SYNC
b
)
b
SYNC option only available for PROTO := MBA or MBB, on rear-panel serial ports.
9600
DATABIT
c
c
For P ROTO : = SEL o n ly.
Data Bits (7, 8 bits) 8
PARITY
c
Parity (Odd, Even, None) N
STOPBIT
d
d
For PROTO := SEL, MBA, MBB, or PMU only.
Stop Bits (1, 2 bits) 1
RTSCTS
e
e
For PROTO := SEL or PMU only.
Enable Hardware Handshaking (Y, N) N
Table 5.38 SEL Protocol Settings
Label Prompt Default Value
TIME-
OUT
a
a
Hidden for PROTO := PMU.
Port Time-Out (OFF, 1–60 minutes) 5
AUTO
b
b
Hidden for PROTO := DNP or PMU.
Send Auto-Messages to Port (Y, N) Y
FASTOP
c
c
Hidden for PROTO := DNP.
Enable Fast Operate Messages (Y, N) N
TERTIM1
a
Initial Delay-Disconnect Sequence (0–600 seconds) 1
TER-
STRN
a
Termination String-Disconnect Sequence
(9 characters maximum)
d
d
TERSTRN set at \005 is <Ctrl+E>.
“\005”
TERTIM2
a
Final Delay-Disconnect Sequence (0–600 seconds) 0
Table 5.39 Fast Message Read Data Access
Label Prompt Default Value
FMRENAB Enable Fast Message Read Data Access (Y/N) Y
FMRLCL Enable Local Region for Fast Message Access (Y/N) N
FMRMTR Enable Meter Region for Fast Message Access (Y/N) Y
FMRDMND Enable Demand Region for Fast Message Access (Y/N) Y
FMRTAR Enable Target Region for Fast Message Access (Y/N) Y
FMRHIS Enable History Region for Fast Message Access (Y/N) N
FMRBRKR Enable Breaker Region for Fast Message Access (Y/N) N
FMRSTAT Enable Status Region for Fast Message Access (Y/N) N
FMRANA Enable Analog Region for Fast Message Access (Y/N) Y
To Next Page
Loading...
