1-22
By default, the interval between sending jitter test packets is 20 milliseconds.
Related commands: jitter-packetnum.
The jitter-interval command applies to jitter tests only.
Examples
# Set the interval between sending jitter test packets to 30 milliseconds.
<Sysname> system-view
System View: return to User View with Ctrl+Z
[Sysname] hwping administrator jitter
[Sysname-hwping-administrator-jitter] test-type jitter
[Sysname-hwping-administrator-jitter] jitter-interval 30
jitter-packetnum
Syntax
jitter-packetnum number
undo jitter-packetnum
View
HWPing test group view
Parameters
number: Number of packets to be transmitted in one probe for a jitter test, in the range of 10 to 1000.
Description
Use the jitter-packetnum command to configure the number of packets to be sent in one probe for a
jitter test.
Use the undo jitter-packetnum command to restore the default.
By default, 10 packets are sent in a probe for a jitter test.
Related commands: jitter-interval.
This command applies to jitter tests only.
Examples
# Configure to send 30 packets in a probe for a jitter test.
<Sysname> system-view
System View: return to User View with Ctrl+Z
[Sysname] hwping administrator jitter
[Sysname-hwping-administrator-jitter] test-type jitter
[Sysname-hwping-administrator-jitter] jitter-packetnum 30
To Next Page
Loading...
Need help?
General