H3C S3100 Series Command Manual

1-14
Parameters
all: Displays the total number of all neighbor entries, including neighbor entries acquired dynamically
and configured statically.
dynamic: Displays the total number of all neighbor entries acquired dynamically.
static: Displays the total number of all neighbor entries configured statically.
interface interface-type interface-number: Displays the total number of neighbor entries of a specified
interface.
vlan vlan-id: Displays the total number of neighbor entries of a specified VLAN, in the range of 1 to
4,094.
count: Number of neighbor entries.
Description
Use the display ipv6 neighbors count command to display the total number of neighbor entries
satisfying the specified condition.
Examples
# Display the total number of neighbor entries acquired dynamically.
<Sysname> display ipv6 neighbors dynamic count
Total dynamic entry(ies): 3
display ipv6 route-table
Syntax
display ipv6 route-table [ verbose ]
View
Any view
Parameters
verbose: Displays detailed information about the IPv6 routing table.
Description
Use the display ipv6 route-table command to display brief information about the routing table,
including the destination IP address, prefix length, type of protocol, next hop, egress interface, and so
on. In this case, only the valid route entries are displayed,
Use the display ipv6 route-table verbose command to display detailed information about the routing
table. In this case, both valid routes and invalid routes are displayed.
Examples
# Display summary information about the routing table.
<Sysname> display ipv6 route-table
Routing Table:
Destinations : 4 Routes : 4
Destination: ::1/128 Protocol: Direct
NextHop : ::1
Interface : InLoopBack0
Destination: 2008::/64 Protocol: Direct
NextHop : 2008::32

H3C S3100 Series Specifications

General

Brand	H3C
Model	S3100 Series
Category	Switch
Language	English