1-31
Only H3C S3100-EI series switches support this command.
Example
# Clear the statistics on packets that match ACL 2000 and are of VLAN 1 (assuming that the current
device is an S3100-EI series switch).
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] reset traffic-limit vlan 1 inbound ip-group 2000
reset traffic-statistic
Syntax
reset traffic-statistic inbound acl-rule
View
System view, Ethernet port view, Port group view
Parameter
inbound: Specifies to clear the statistics on the inbound packets.
acl-rule: ACL rules to be applied. This argument can be the combination of multiple ACLs. For more
information about this argument, refer to
Table 1-9 and Table 1-10.
Description
Use the reset traffic-statistics command to clear the statistics on all the packets matching specific
ACL rules, or the packets that match specific ACL rules and are of a port group or pass a port.
Related command: traffic-statistic.
Only H3C S3100-EI series switches support this command.
Example
# Clear the statistics on packets matching ACL 2000 and passing Ethernet 1/0/1 (assuming that the
current device is an S3100-EI series switch).
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] interface Ethernet1/0/1
[Sysname-Ethernet1/0/1] reset traffic-statistic inbound ip-group 2000
To Next Page
Loading...
Need help?
General