1-1
1 IGMP Snooping Configuration Commands
Only the S3100-EI series support the IGMP Snooping querier feature. The related commands are as
follows:
z igmp-snooping querier
z igmp-snooping query-interval
z igmp-snooping general-query source-ip
IGMP Snooping Configuration Commands
display igmp-snooping configuration
Syntax
display igmp-snooping configuration
View
Any view
Parameters
None
Description
Use the display igmp-snooping configuration command to display IGMP Snooping configuration
information.
If IGMP Snooping is disabled on this switch, this command displays a message showing that IGMP
Snooping is not enabled.
With IGMP Snooping enabled, this command displays the following information:
z IGMP Snooping status
z aging time of the router port
z maximum response time in IGMP queries
z aging time of multicast member ports
z non-flooding feature status
Related commands: igmp-snooping, igmp-snooping router-aging-time, igmp-snooping
host-aging-time.
Examples
# Display IGMP Snooping configuration information on the switch.
To Next Page
Loading...
Need help?
General