3-3
Default Level
2: System level
Parameters
interface-list: Specifies a port in the form of interface-type interface-number, or a port range in the form
of interface-type start-interface-number to interface-type end-interface-number, where the end
interface number must be greater than the start interface number.
all: Deletes all the ports in the current IPv6 multicast VLAN.
Description
Use the port command to assign port(s) to the current IPv6 multicast VLAN.
Use the undo port command to delete port(s) from the current IPv6 multicast VLAN.
By default, an IPv6 multicast VLAN has no ports.
Note that:
z A port can belong to only one IPv6 multicast VLAN.
z Only the Ethernet interfaces can be configured as IPv6 multicast VLAN ports.
Examples
# Assign ports Ethernet 1/0/1 through Ethernet 1/0/5 to IPv6 multicast VLAN 100.
<Sysname> system-view
[Sysname] multicast-vlan ipv6 100
[Sysname-ipv6-mvlan-100] port Ethernet 1/0/1 to Ethernet 1/0/5
port multicast-vlan ipv6
Syntax
port multicast-vlan ipv6 vlan-id
undo port multicast-vlan ipv6
View
Ethernet port view.
Default Level
2: System level
Parameters
vlan-id: VLAN ID of the IPv6 multicast VLAN you want to assign the current port(s) to, in the range of 1
to 4094.
Description
Use the port multicast-vlan ipv6 command to assign the current port(s) to the specified IPv6 multicast
VLAN.
Use the undo port multicast-vlan ipv6 command to restore the system default.
By default, a port does not belong to any IPv6 multicast VLAN.
Note that a port can belong to only one IPv6 multicast VLAN.
Examples
# Assign Ethernet 1/0/1 to IPv6 multicast VLAN 100.
To Next Page
Loading...
Need help?
General