2-47
Parameters
None
Description
Use the display cluster black-list command to display the information of devices in the current cluster
blacklist.
Related commands: black-list.
Examples
# Display the contents of the current cluster blacklist.
<aaa_0.Sysname> display cluster black-list
Device ID Access Device ID Access port
000f-e200-5502 000f-e202-2180 Ethernet1/0/24
00e0-fd34-bc66 000f-e202-2180 Ethernet1/0/1
Table 2-11 Description on the fields of the display cluster black-list command
Field Description
Device ID
ID of the device in the blacklist, expressed by the
MAC address of the device
Access Device ID
ID of the device (in the cluster) that is connected
with a device in the blacklist, expressed by the
MAC address of the device
Access port
Port (in the cluster) that is connected with a
device in the blacklist
display cluster current-topology
Syntax
display cluster current-topology [ mac-address mac-address1 [ to-mac-address mac-address2 ] |
member-id member-id1 [ to-member-id member-id2 ] ]
View
Any view
Parameters
mac-address mac-address1: Displays the topology structure three layers above or below the node
specified by the MAC address. If to-mac-address is specified, mac-address1 is the start point of the
route in the specified route topology displayed.
to-mac-address mac-address2: Displays the topology structure of the route from mac-address1 to
mac-address2.
member-id member-id1: Displays the structure of the standard topology three layers above or below
the node specified by the member ID. If to-member-id is specified, member-id1 is the start point of the
route in the specified route topology displayed.
to-member-id member-id2: Displays the topology structure of the route from member-id1 to
member-id2.
To Next Page
Loading...
Need help?
General