1-19
Level: 6 Maintenance domain: mdtest_6
Level: 7 Maintenance domain: mdtest_7
Table 1-7 display cfd md command output description
Field Description
8 maintenance domain(s) configured Number of MDs configured
Level Level of MD, each level allows only one MD.
Maintenance domain Name of MD
display cfd mep
Syntax
display cfd mep mep-id service-instance instance-id
View
Any view
Default Level
2: System level
Parameters
mep mep-id: Specifies a MEP by its ID, ranging from 1 to 8191.
service-instance instance-id: Specifies a service instance by its ID, ranging from 1 to 32767.
Description
Use the display cfd mep command to display the attribute and operating information of a MEP or
multiple MEPs.
Examples
# Display the attribute and operating information of MEP 50 in service instance 1.
<Sysname> display cfd mep 50 service-instance 1
Interface: Ethernet1/0/2
Maintenance domain: mdtest_1
Maintenance association: matest_1
Level: 1 VLAN: 1 Direction: Outbound
Administrative state: Active CCM send: Enable
FNG state: FNG_DEFECT_REPORTED
CCM:
Current state: CCI_WAITING
Interval: 1s SendCCM: 12018
Loopback:
NextSeqNumber: 8877
SendLBR: 0 ReceiveInOrderLBR: 0 ReceiveOutOrderLBR: 0
Linktrace:
NextSeqNumber: 8877
SendLTR: 0 ReceiveLTM: 0
To Next Page
Loading...
Need help?
General