2-3
Parameters
interface interface-type interface-number: Specify the port to be bound. The interface-type
interface-number arguments indicate the port type and port number.
ip-addr ip-address: Specify the IP address to be bound.
mac-addr mac-address: Specify the MAC address to be bound. The mac-address argument is in the
form of H-H-H.
Description
Use the display am user-bind command to display port binding information.
If no keyword is specified, this command displays all port bindings.
Related commands: am user-bind.
Examples
# Display all port bindings.
<Sysname> display am user-bind
Following User address bind have been configured:
Mac IP Port
000f-e200-5101 10.153.1.1 Ethernet1/0/1
000f-e200-5102 10.153.1.2 Ethernet1/0/2
Unit 1:Total 2 found, 2 listed.
Total: 2 found.
The above output displays that two port binding settings exist on unit 1:
z MAC address 000f-e200-5101 and IP address 10.153.1.1 are bound to Ethernet 1/0/1.
z MAC address 000f-e200-5102 and IP address 10.153.1.2 are bound to Ethernet 1/0/2.
display am user-bind ipv6
Syntax
display am user-bind ipv6 [ interface interface-type interface-number | ipv6-address | mac-addr
mac-address | unit unit-id ]
View
Any view
Parameters
interface interface-type interface-number: Displays the bindings of a port. The interface-type
interface-number arguments indicate the port type and port number.
ipv6-address: Specify the bindings of an IPv6 address.
mac-addr mac-address: Displays the bindings of a MAC address. The mac-address argument is in the
form of H-H-H.
unit unit-id: Displays the bindings of a unit ID.
To Next Page
Loading...
Need help?
General