1-7
By default, alert mode is used, by which a switch prompts for confirmation before performing file-related
operations that have potential risks.
If you set the prompt mode of the file-related operations to quiet, the switch does not prompt for
confirmation before performing file-related operations. In this case, the system is more likely to be
damaged due to some maloperations. For example:
z If the prompt mode is set to alert, the following messages will be displayed when you delete a file:
<Sysname> delete flash:/te.txt
Delete unit1>flash:/te.txt?[Y/N]:y
......
%Delete file unit1>flash:/te.txt...Done.
The system waits for you to confirm for 30 seconds. If you do not input any confirmation in 30 seconds,
the system cancels this file operation, as shown in the following:
<Sysname> delete flash:/tt.txt
Delete unit1>flash:/tt.txt?[Y/N]:
<Sysname>
z If the prompt mode is set to quiet, the following messages will be displayed when you delete a file:
<Sysname> delete flash:/te.txt
....
%Delete file unit1>flash:/te.txt...Done.
Example
# Set the prompt mode to quiet for file-related operations.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] file prompt quiet
fixdisk
Syntax
fixdisk device
View
User view
Parameter
device: Name of a device which must be “unit1>flash:” or “flash:” for S3100 series Ethernet switches.
Description
Use the fixdisk command to restore space on the Flash memory.
In case that space on the Flash memory may become unavailable for reasons such as abnormal
operations, you can run this command to restore the space.
Example
# Restore space on the Flash memory.
<Sysname> fixdisk unit1>flash:
Fixdisk flash: may take some time to complete.
%Fixdisk unit1>flash: completed.
To Next Page
Loading...
Need help?
General