1-5
For the S3100-SI series switch, create the VLAN interface for the management VLAN on a switch
operating as the management device in a cluster, make sure that the management VLAN ID is
consistent with the cluster management VLAN ID configured with the management-vlan vlan-id
command. Otherwise, the configuration fails. Refer to the Cluster Operation Manual for detailed
introduction to the cluster.
Examples
# Create the VLAN interface for VLAN 1 and enter VLAN-interface 1 view.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] interface Vlan-interface 1
[Sysname-Vlan-interface1]
name
Syntax
name text
undo name
View
VLAN view
Parameters
text: VLAN name, a description of 1 to 32 characters. It can contain special characters and spaces.
Description
Use the name command to assign a name to the current VLAN.
Use the undo name command to restore the default VLAN name.
When 802.1x or MAC address authentication is configured on the switch, a RADIUS server may be
used to deploy VLANs (either named or numbered) on the ports that have passed authentication. If a
named VLAN is deployed, you must use the name command to associate the VLAN name with the
intended VLAN ID. The name of a VLAN must be unique among all VLANs.
By default, the name of a VLAN is its VLAN ID, VLAN 0001 for example.
Examples
# Specify the name of VLAN 2 as test vlan.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] vlan 2
[Sysname-vlan2] name test vlan
To Next Page
Loading...
Need help?
General