1-7
[Sysname] info-center console channel 0
info-center enable
Syntax
info-center enable
undo info-center enable
View
System view
Parameter
None
Description
Use the info-center enable command to enable the information center.
Use the undo info-center enable command to disable the information center.
The switch can output system information to the log host, the console, and other destinations only when
the information center is enabled.
By default, the information center is enabled.
Related command: display info-center, info-center loghost, info-center logbuffer, info-center
console channel, info-center monitor channel, info-center trapbuffer, info-center snmp channel.
Example
# Enable the information center.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] info-center enable
% Information center is enabled
info-center logbuffer
Syntax
info-center logbuffer [ channel { channel-number | channel-name } | size buffersize ]*
undo info-center logbuffer [ channel | size ]
View
System view
Parameter
channel: Sets the channel through which information outputs to the log buffer.
channel-number: Channel number, ranging from 0 to 9, corresponding to the 10 channels of the system.
channel-name: Channel name, by default, the name of channel 0 to channel 9 is (in turn) console,
monitor, loghost, trapbuffer, logbuffer, snmpagent, channel6, channel7, channel8, channel9.
size buffersize: Specifies the size of the log buffer (number of messages the buffer holds) you want to
display. The buffersize argument ranges from 0 to 1,024 and defaults to 512.
Description
Use the info-center logbuffer command to enable information output to the log buffer.
To Next Page
Loading...
Need help?
General