1-6
port-group group-id: Displays information about packet filtering on the port group specified by group-id.
unitid unit-id: Displays information about packet filtering on the unit specified by unit-id. The unit ID can
be set only to 1.
vlan vlan-id: Displays information about packet filtering on the VLAN specified by vlan-id.
Description
Use the display packet-filter command to display information about packet filtering.
Only H3C S3100-EI series switches support this command.
Example
# Display information about packet filtering on the switch.
<Sysname> display packet-filter unitid 1
Ethernet1/0/1
Inbound:
Acl 2000 rule 0 running
Table 1-3 Description on the fields of the display packet-filter command
Field Description
Ethernet1/0/1 Packet filtering is performed on Ethernet1/0/1.
Inbound Packet filtering is performed in the inbound direction.
Acl 2000 rule 0 The rule 0 of ACL 2000 is used.
running
Status of the rule, which can be
z running: The ACL rule is active.
z not running: The ACL rule is inactive. Usually, this is because the
current time is out of the rule’s time range.
display time-range
Syntax
display time-range { all | time-name }
View
Any view
Parameters
all: Displays all time ranges.
time-name: Name of a time range, a string of 1 to 32 characters that starts with a to z or A to Z.
To Next Page
Loading...
Need help?
General