3-1
3 BPDU Tunnel Configuration Commands
This chapter is only applicable to the S3100-EI series Ethernet switches.
BPDU Tunnel Configuration Commands
bpdu-tunnel
Syntax
bpdu-tunnel protocol-type
undo bpdu-tunnel { protocol-type | all }
View
Ethernet port view
Parameters
protocol-type: Protocol type, packets of which will be transmitted through a BPDU tunnel, This
argument can be a keyword listed in
Table 3-1.
Table 3-1 Description on the protocol-name argument
Value Description
cdp
Enable/Disable BPDU tunnel for CISCO
discovery protocol (CDP).
hgmp
Enable/Disable BPDU tunnel for Huawei group
management protocol (HGMP) related protocols,
including neighbor discovery protocol (NDP),
neighbor topology discovery protocol, cluster
member remote control (MRC), and Huawei
authentication bypass protocol (HABP).
lacp
Enable/Disable BPDU tunnel for link aggregation
control protocol (LACP).
pagp
Enable/Disable BPDU tunnel for port
aggregation protocol (PAGP).
pvst
Enable/Disable BPDU tunnel for per-VLAN
spanning tree (PVST).
stp
Enable/Disable BPDU tunnel for spanning tree
protocol (STP).
To Next Page
Loading...
Need help?
General