1-17
interface-list: Ethernet port list. You can specify multiple Ethernet ports by providing this argument in the
format of interface-list ={ interface-type interface-number [ to interface-type interface-number ] }
&<1-10>, where &<1-10> means that you can provide up to 10 port indexes/port index ranges for this
argument.
Description
z Use the stp compliance command in interface view to configure the mode the port(s) will use to
recognize and send MSTP BPDUs. Use the undo stp compliance command to restore the
system default.
z Use the stp interface compliance command in system view to set the mode in which a port
recognizes and sends MSTP packets. Use the undo stp interface compliance command to
restore the default.
The default mode is auto, namely all ports recognize the BPDU format automatically.
Note that:
z If the mode is set to auto on a port, the port automatically recognizes and resolves the received
compatible-format BPDUs or 802.1s-compliant BPDUs, and sends, when needed,
compatible-format or 802.1s-compliant BPDUs.
z If the mode is set to legacy or dot1s on a port, the port can only receive and send BPDUs of the
specified format. If the port is configured not to detect the packet format automatically while it works
in the MSTP mode, and if it receives a packet in the format other than the configured format, it will
become a designated port and remain in the discarding state to prevent the occurrence of a loop.
Examples
# Configure Ethernet 1/0/1 to recognize and send MSTP BPDUs in dot1s format.
z In Ethernet port view.
<Sysname> system-view
Enter system view, return to user view with Ctrl+Z.
[Sysname] interface Ethernet 1/0/1
[Sysname-Ethernet1/0/1] stp compliance dot1s
z In system view.
<Sysname> system-view
Enter system view, return to user view with Ctrl+Z.
[Sysname] stp interface Ethernet1/0/1 compliance dot1s
# Configure Ethernet 1/0/2 to Ethernet 1/0/4 to recognize and send MSTP BPDUs in dot1s format.
<Sysname> system-view
[Sysname] stp interface Ethernet 1/0/2 to Ethernet1/0/4 compliance dot1s
stp config-digest-snooping
Syntax
z System view, Ethernet port view:
stp config-digest-snooping
undo stp config-digest-snooping
z System view:
stp interface interface-list config-digest-snooping
To Next Page
Loading...
