1-74
Examples
# Clear all HWTACACS protocol statistics.
<Sysname> reset hwtacacs statistics all
reset stop-accounting-buffer
Syntax
reset stop-accounting-buffer hwtacacs-scheme hwtacacs-scheme-name
View
User view
Parameters
hwtacacs-scheme hwtacacs-scheme-name: Deletes the buffered stop-accounting requests of a
specified HWTACACS scheme. Here, hwtacacs-scheme-name is the name of a HWTACACS scheme,
which is a string of up to 32 characters.
Description
Use the reset stop-accounting-buffer command to clear stop-accounting requests that are buffered
on the switch due to getting no response.
Related commands: stop-accounting-buffer enable, retry stop-accounting, display
stop-accounting-buffer.
Examples
# Delete the stop-accounting requests buffered for HWTACACS scheme hwt1.
<Sysname> reset stop-accounting-buffer hwtacacs-scheme hwt1
retry stop-accounting
Syntax
retry stop-accounting retry-times
undo retry stop-accounting
View
HWTACACS scheme view
Parameters
retry-times: Maximum number of transmission attempts of a stop-accounting request, ranging from 1 to
300.
Description
Use the retry stop-accounting command to enable the stop-accounting request retransmission
function and set the maximum number of attempts to transmit a stop-accounting request.
Use the undo retry stop-accounting command to restore the default setting.
By default, this function is enabled and the maximum number of transmission attempts is 100.
To Next Page
Loading...
Need help?
General