2-2
Field Description
Last-up-time Last time the port is up
Last-down-time
Last time the port is down
link-aggregation group
Syntax
link-aggregation group group-id{ uplink | downlink }
undo link-aggregation group group-id
View
Monitor Link group view
Parameter
group-id: Link aggregation group ID, ranging from 1 to 28 (A link aggregation group can be a manual or
static link aggregation group only).
uplink: Configures the specified link aggregation group as the uplink port of the Monitor Link group
downlink: Configures the specified link aggregation group as the downlink port of the Monitor Link
group
Description
Use the link-aggregation group command to configure the specified link aggregation group as a
Monitor Link group member.
Use the undo link-aggregation group command to remove the specified link aggregation group from
the current Monitor Link group.
In Monitor Link, a Monitor Link group member can be a single port, a manual or static link aggregation
group, but not a dynamic link aggregation group. Uplink port can also be a Smart Link group.
Use this command only on the link aggregation groups that are not Smart Link group members.
A port or a link aggregation group cannot serve as a member port for two Smart Link groups. On the
other hand, a port or a link aggregation group cannot serve as a member of a Smart Link group and a
Monitor Link group at the same time. However, a Smart Link group can serve as the uplink member port
of a Monitor Link group.
Example
# Configure link aggregation group 8 as the downlink port of the Monitor Link group.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
To Next Page
Loading...
Need help?
General