1-11
unit-id: Unit ID, which is fixed to 1. With this argument specified, the traffic redirecting configuration of all
the ports on the device is displayed.
Description
Use the display qos-interface traffic-redirect command to display the traffic redirecting configuration
of a port or all the ports on the device.
Related command: traffic-redirect.
Only H3C S3100-EI series switches support this command.
Example
# Display the traffic redirecting configuration of Ethernet 1/0/1 (assuming that the current device is an
S3100-EI series switch).
<Sysname> display qos-interface Ethernet 1/0/1 traffic-redirect
Ethernet1/0/1: traffic-redirect
Inbound:
Matches: Acl 2000 rule 0 running
Redirected to: interface Ethernet1/0/2
Table 1-5 Description on the fields of the display qos-interface traffic-redirect command
Field Description
Ethernet1/0/1 Port with traffic redirecting configured
Inbound Packet direction
Matches ACL rules for traffic classification
Redirected to
z “interface” indicates that the packets are redirected to the port.
z “cpu” indicates that the packets are redirected to the CPU.
display qos-interface traffic-remark-vlanid
Syntax
display qos-interface { interface-type interface-number | unit-id } traffic-remark-vlanid
View
Any view
Parameters
interface-type interface-number: Specifies a port by its type and number.
unit-id: Unit ID, which is fixed to 1.
To Next Page
Loading...
Need help?
General