2-37
Examples
# Configure a private IP address pool for a cluster.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] cluster
[Sysname-cluster] ip-pool 10.200.0.1 20
logging-host
Syntax
logging-host ip-address
undo logging-host
View
Cluster view
Parameters
ip-address: IP address of the device to be configured as the log host of a cluster.
Description
Use the logging-host command to configure a shared log host for a cluster on the management
device.
Use the undo logging-host command to remove the shared log host setting.
By default, no shared log host is configured.
After setting the IP address of a log host for the cluster, the member devices in the cluster can send logs
to the log host through the management device.
Note that you must execute the command on a management device.
For how to configure a switch to send logs to the log host, refer to Information Center Operation.
Examples
# Configure the device with IP address 10.10.10.9 as the log host of a cluster.
<aaa_0.Sysname> system-view
System View: return to User View with Ctrl+Z.
[aaa_0.Sysname] cluster
[aaa_0.Sysname-cluster] logging-host 10.10.10.9
To Next Page
Loading...
Need help?
General