H3C S3100 Series Command Manual

1-9
Description
Use the cfd mep command to create a MEP on a port.
Use the undo cfd mep command to delete the specified MEP.
By default, no MEP exists on a port.
Note that:
z In creating a MEP, the service instance you specified defines the MD and MA that the MEP belongs
to.
z You cannot create a MEP if the MEP ID is not included in the MEP list of the corresponding service
instance.
Related commands: cfd meplist.
Examples
# Configure a MEP list in service instance 5, and create and enable inward-facing MEP 3 in service
instance 5 on Ethernet 1/0/1.
<Sysname> system-view
[Sysname] cfd md test_md level 3
[Sysname] cfd ma test_ma md test_md vlan 100
[Sysname] cfd service-instance 5 md test_md ma test_ma
[Sysname] cfd meplist 3 service-instance 5
[Sysname] interface ethernet 1/0/1
[Sysname-Ethernet1/0/1] cfd mep 3 service-instance 5 inbound
cfd mep enable
Syntax
cfd mep service-instance instance-id mep mep-id enable
undo cfd mep service-instance instance-id mep mep-id enable
View
Ethernet interface view
Default Level
2: System level
Parameters
service-instance instance-id: Specifies the service instance ID, ranging from 1 to 32767.
mep mep-id: Specifies the ID of a MEP, ranging from 1 to 8191.
Description
Use the cfd mep enable command to enable the MEP configured on a port.
Use the undo cfd mep enable command to disable the MEP.
By default, MEP is disabled on a port and cannot respond to LTM and LBM messages unless you
enable it.
Related commands: cfd mep.
Examples
# Enable MEP 3 in service instance 5.
<Sysname> system-view

H3C S3100 Series Specifications

General

Brand	H3C
Model	S3100 Series
Category	Switch
Language	English