2-4
Examples
# Set 802.1p precedence for MLD messages to 3 globally.
<Sysname> system-view
[Sysname] mld-snooping
[Sysname-mld-snooping] dot1p-priority 3
drop-unknown (MLD-Snooping view)
Syntax
drop-unknown
undo drop-unknown
View
MLD-Snooping view
Default Level
2: System level
Parameters
None
Description
Use the drop-unknown command to enable dropping unknown IPv6 multicast data globally.
Use the undo drop-unknown command to disable dropping unknown IPv6 multicast data globally.
By default, this function is disabled, that is, unknown IPv6 multicast data is flooded in the VLAN.
This command works only on MLD snooping–enabled VLANs.
Examples
# Globally enable the device to drop unknown IPv6 multicast data.
<Sysname> system-view
[Sysname] mld-snooping
[Sysname-mld-snooping] drop-unknown
entry-limit (MLD-Snooping view)
Syntax
entry-limit limit
undo entry-limit
View
MLD-Snooping view
Default Level
2: System level
Parameters
limit: Maximum number of entries in the MLD snooping forwarding table, in the range of 0 to 512.
To Next Page
Loading...
Need help?
General