H3C S3100 Series

1-1
1 Mirroring Commands
Mirroring Commands
display mirroring-group
Syntax
display mirroring-group { group-id | all | local | remote-destination | remote-source }
View
Any view
Parameters
group-id: Specifies the mirroring group of which the configurations are to be displayed, the value of
which can only be 1.
all: Specifies to display the parameter settings of all mirroring groups.
local: Specifies to display the parameter settings of local port mirroring groups.
remote-destination: Specifies to display the parameter settings of the destination groups for remote
mirroring.
remote-source: Specifies to display the parameter settings of the source groups for remote mirroring.
Description
Use the display mirroring-group command to display port mirroring configurations.
Related commands: mirroring-group mirroring-port, mirroring-group monitor-port.
Examples
# Display the configurations of a local mirroring group on your S3100-EI series Ethernet switch.
<Sysname> display mirroring-group 1
mirroring-group 1:
type: local
status: active
mirroring port:
Ethernet1/0/1 both
monitor port: Ethernet1/0/4
# Display the configurations of a remote source mirroring group on your S3100-EI series Ethernet
switch.
<Sysname> display mirroring-group 1
mirroring-group 1:
type: remote-source
status: active
mirroring port: