2-1
2 Quick EAD Deployment Configuration Commands
The command introduced in this chapter is only supported by the S3100-EI series switches.
Quick EAD Deployment Configuration Commands
dot1x free-ip
Syntax
dot1x free-ip ip-address { mask-address | mask-length }
undo dot1x free-ip [ ip-address { mask-address | mask-length } ]
View
System view
Parameters
ip-address: Free IP address, in dotted decimal notation.
mask-address: Subnet mask of the free IP address, in dotted decimal notation.
mask-length: Length of the subnet mask of the free IP address, in the range 0 to 32.
Description
Use the dot1x free-ip command to configure a free IP range. A free IP range is an IP range that users
can access before passing 802.1x authentication.
Use the undo dot1x free-ip command to remove a specified free IP range or all free IP ranges.
By default, no free IP range is configured.
z You must configure the URL for HTTP redirection before configuring a free IP range.
z The device supports up to two free IP ranges.
Examples
# Configure a free IP range for users to access before passing authentication.
To Next Page
Loading...
Need help?
General