H3C S3100 Series - Lldp Admin-Status; Lldp Check-Change-Interval

1-14
Field Description
LLDP-MED extend TLV
MED related LLDP TLVs, including:
z Capabilities TLV
z Network Policy TLV
z Extended Power-via-MDI TLV
z Location Identification TLV
z Inventory TLV, which can be hardware revision TLV, firmware
revision TLV, software revision TLV, serial number TLV,
manufacturer name TLV, model name TLV, and asset id TLV.
lldp admin-status
Syntax
lldp admin-status { disable | rx | tx | txrx }
undo lldp admin-status
View
Ethernet interface view
Parameters
disable: Specifies the Disable mode. A port in this mode does not send or receive LLDPDUs.
rx: Specifies the Rx mode. A port in this mode receives LLDPDUs only.
tx: Specifies the Tx mode. A port in this mode sends LLDPDUs only.
txrx: Specifies the TxRx mode. A port in this mode sends and receives LLDPDUs.
Description
Use the lldp admin-status command to specify the LLDP operating mode for a port or all the ports in a
port group.
Use the undo lldp admin-status command to restore the default LLDP operating mode.
The default LLDP operating mode is TxRx.
Examples
# Configure the LLDP operating mode as Rx for Ethernet1/0/1.
<Sysname> system-view
[Sysname] interface ethernet 1/0/1
[Sysname-Ethernet1/0/1] lldp admin-status rx
lldp check-change-interval
Syntax
lldp check-change-interval interval
undo lldp check-change-interval
View
Ethernet interface view