1-5
Use the undo databits command to revert to the default databits.
The default databits is 8.
z This command takes effect on AUX user interfaces only.
z The databits setting on the terminal and that on the device user interface must be the same for
communication.
Examples
# Set the databits to 7.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] user-interface aux 0
[Sysname-ui-aux0] databits 7
display user-interface
Syntax
display user-interface [ type number | number ] [ summary ]
View
Any view
Parameters
type: User interface type, which can be AUX (for AUX user interface) and VTY (for VTY user interface).
number: User interface index. A user interface index can be relative or absolute.
z In relative user interface number scheme, the type argument is required. In this case, AUX user
interfaces is numbered AUX0; VTY user interfaces are numbered from VTY0 through VTY4.
z In absolute user interface number scheme, the type argument is not required. In this case, user
interfaces are numbered from 0 to 5.
summary: Displays the summary information about a user interface.
Description
Use the display user-interface command to display the information about a specified user interface or
all user interfaces. If the summary keyword is not specified, this command displays user interface type,
absolute/relative user interface index, transmission speed, available command level, authentication
mode, and physical position. If the summary keyword is specified, this command displays the number
and type of the user interfaces, including those that are in use and those that are not in use.
Examples
# Display the information about user interface 0.
<Sysname> display user-interface 0
To Next Page
Loading...
Need help?
General