1-2
Table 1-1 Description on the fields of the display garp statistics command
Field Description
Number of GVRP Frames Received Number of the GVRP frames received on the port
Number of GVRP Frames Transmitted
Number of the GVRP frames transmitted through the
port
Number of Frames Discarded Number of GVRP frames discarded by the port
display garp timer
Syntax
display garp timer [ interface interface-list ]
View
Any view
Parameters
interface-list: Specifies a list of Ethernet ports of which the GARP timer settings are to be displayed. In
this list, you can specify individual ports and port ranges. An individual port takes the form of
interface-type interface-number and a port range takes the form of interface-type interface-number1 to
interface-type interface-number2, with interface-number2 taking a value greater than
interface-number1. The total number of individual ports and port ranges defined in the list must not
exceed 10.
Description
Use the display garp timer command to display the settings of the GARP timers on specified ports or
all ports.
If the interface interface-list keyword-argument combination is not specified, this command displays
the GARP timer settings of all ports.
This command displays the settings of the following timers:
z Join timer
z Leave timer
z LeaveAll timer
z Hold timer
Related commands: garp timer, garp timer leaveall.
Examples
# Display the settings of the GARP timers on port Ethernet1/0/1.
<Sysname> display garp timer interface Ethernet 1/0/1
GARP timers on port Ethernet1/0/1
Garp Join Time : 20 centiseconds
Garp Leave Time : 60 centiseconds
Garp LeaveAll Time : 1000 centiseconds
Garp Hold Time : 10 centiseconds
To Next Page
Loading...
Need help?
General