1-14
Only H3C S3100-EI series switches support this command.
Example
# Display the traffic accounting configuration information and traffic statistics on Ethernet 1/0/1
(assuming that the current device is an S3100-EI series switch).
<Sysname> display qos-interface Ethernet 1/0/1 traffic-statistic
Ethernet1/0/1: traffic-statistic
Inbound:
Matches: Acl 2000 rule 0 running
8251 packet
Table 1-8 Description on the fields of the display qos-interface traffic-statistic command
Field Description
Ethernet1/0/1 Port with the traffic accounting function configured
Inbound Packet direction
Matches ACL rules for traffic classification
8251 packet Statistics on matched packets
display qos-port-group
Syntax
display qos-port-group [ group-id ] { all | mirrored-to | traffic-limit | traffic-priority | traffic-redirect
| traffic-statistic }
View
Any view
Parameter
group-id: Port group ID, in the range 1 to 100. If this argument is not specified, the QoS information of all
the port groups is displayed.
all: Displays all the QoS-related configurations of a port group.
traffic-limit: Displays the traffic policing configuration of a port group.
traffic-priority: Displays the priority marking configuration of a port group.
traffic-redirect: Displays the traffic redirecting configuration of a port group.
traffic-statistics: Displays the traffic accounting configuration of a port group.
Description
Use the display qos-port-group command to display specific QoS-related configuration of a port
group.
To Next Page
Loading...
Need help?
General