1-24
Parameters
string: Assigned VLAN name, a string of up to 32 characters.
Description
Use the name command to set a VLAN name, which will be used for VLAN assignment.
Use the undo name command to cancel the VLAN name.
By default, a VLAN uses its VLAN ID (like VLAN 0001) as its assigned VLAN name.
This command is used in conjunction with the dynamic VLAN assignment function. For details about
dynamic VLAN assignment, refer to the vlan-assignment-mode command.
Related commands: vlan-assignment-mode.
Examples
# Set the name of VLAN 100 to test.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] vlan 100
[Sysname-vlan100] name test
password
Syntax
password { simple | cipher } password
undo password
View
Local user view
Parameters
simple: Specifies the password in plain text.
cipher: Specifies the password in cipher text.
password: Password to be set:
z For simple mode, the password you input must be a plain-text password.
z For cipher mode, the password can be either a cipher-text password or a plain-text password, and
what it is depends on your input.
A password in plain text can be a string of up to 63 consecutive characters, for example, aabbcc. A
password in cipher text can be a string of 24 or 88 characters, for example,
(TT8F]Y\5SQ=^Q`MAF4<1!!.
Description
Use the password command to set a password for the local user.
Use the undo password command to cancel the password of the local user.
Note that:
z With the local-user password-display-mode cipher-force command configured, the password is
always displayed in cipher text, regardless of the configuration of the password command.
To Next Page
Loading...
Need help?
General