1-9
Related command: info-center enable, display info-center.
Example
# Configure the system to output system information to the Unix log host whose IP address is
202.38.160.1.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] info-center loghost 202.38.160.1
info-center loghost source
Syntax
info-center loghost source interface-type interface-number
undo info-center loghost source
View
System view
Parameter
interface-type: Specifies an interface type.
interface-number: Specifies an interface number.
Description
Use the info-center loghost source command to configure the source interface through which
information is sent to the log host.
Use the undo info-center loghost source command to cancel the source interface configuration.
Related command: info-center enable, display info-center.
Example
# Configure VLAN-interface 1 as the source interface through which information is sent to the log host.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] info-center loghost source Vlan-interface 1
info-center monitor channel
Syntax
info-center monitor channel { channel-number | channel-name }
undo info-center monitor channel
View
System view
Parameter
channel-number: Channel number, ranging from 0 to 9, corresponding to the 10 channels of the system.
channel-name: Channel name, by default, the name of channel 0 to channel 9 is (in turn) console,
monitor, loghost, trapbuffer, logbuffer, snmpagent, channel6, channel7, channel8, channel9.
To Next Page
Loading...
Need help?
General