3-2
multicast-vlan ipv6
Syntax
multicast-vlan ipv6 vlan-id
undo multicast-vlan ipv6 { all | vlan-id }
View
System view
Default Level
2: System level
Parameters
vlan-id: Specifies a VLAN by its ID, in the range of 1 to 4094.
all: Deletes all IPv6 multicast VLANs.
Description
Use the multicast-vlan ipv6 command to configure the specified VLAN as an IPv6 multicast VLAN and
enter IPv6 multicast VLAN view.
Use the undo multicast-vlan ipv6 command to remove the specified VLAN as an IPv6 multicast
VLAN.
No VLAN is an IPv6 multicast VLAN by default.
Note that:
z The specified VLAN to be configured as an IPv6 multicast VLAN must exist.
z For a port-based IPv6 multicast VLAN, you need to enable MLD Snooping in both the IPv6
multicast VLAN and all the user VLANs.
Related commands: mld-snooping enable.
Examples
# Enable MLD Snooping in VLAN 100. Configure it as an IPv6 multicast VLAN and enter IPv6 multicast
VLAN view.
<Sysname> system-view
[Sysname] mld-snooping
[Sysname-mld-snooping] quit
[Sysname] vlan 100
[Sysname-vlan100] mld-snooping enable
[Sysname-vlan100] quit
[Sysname] multicast-vlan ipv6 100
[Sysname-ipv6-mvlan-100]
port (IPv6 multicast VLAN view)
Syntax
port interface-list
undo port { all | interface-list }
View
IPv6 multicast VLAN view
To Next Page
Loading...
Need help?
General