1-69
z You can specify the source address of outgoing HWTACACS messages to avoid messages
returned from server from being unable to reach their destination due to physical interface trouble.
It is recommended to use a Loopback interface address as the source IP address.
z You can specify only one source IP address by using this command. When you re-execute this
command again, the newly set source IP address will overwrite the old one.
Related commands: nas-ip.
Examples
# Configure the switch to use source address 129.10.10.1 for outgoing HWTACACS messages.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] hwtacacs nas-ip 129.10.10.1
hwtacacs scheme
Syntax
hwtacacs scheme hwtacacs-scheme-name
undo hwtacacs scheme hwtacacs-scheme-name
View
System view
Parameters
hwtacacs-scheme-name: HWTACACS scheme name, a string of 1 to 32 characters.
Description
Use the hwtacacs scheme command to create an HWTACACS scheme and enter its view.
Use the undo hwtacacs scheme command to delete an HWTACACS scheme.
By default, no HWTACACS scheme exists.
Examples
# Create an HWTACACS scheme named "hwt1" and enter the corresponding HWTACACS scheme
view.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] hwtacacs scheme hwt1
[Sysname-hwtacacs-hwt1]
key
Syntax
key { accounting | authentication | authorization } string
undo key { accounting | authentication | authorization }
To Next Page
Loading...
Need help?
General