1-70
View
HWTACACS scheme view
Parameters
accounting: Sets a shared key for HWTACACS accounting messages.
authentication: Sets a shared key for HWTACACS authentication messages.
authorization: Sets a shared key for HWTACACS authorization messages.
string: Shared key to be set, a string of up to 16 characters.
Description
Use the key command to configure a shared key for HWTACACS authentication, authorization or
accounting messages.
Use the undo key command to delete such a configuration.
By default, no key is set for HWTACACS messages.
Related commands: display hwtacacs.
Examples
# Use hello as the shared key for HWTACACS accounting messages in HWTACACS scheme hwt1.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] hwtacacs scheme hwt1
[Sysname-hwtacacs-hwt1] key accounting hello
nas-ip
Syntax
nas-ip ip-address
undo nas-ip
View
HWTACACS scheme view
Parameters
ip-address: Source IP address to be set, an IP address of this device. This address can neither be the
all 0's address nor be a Class D address.
Description
Use the nas-ip command to set the source address of outgoing HWTACACS messages.
Use the undo nas-ip command to restore the default setting.
Note that:
z You can set the source address of HWTACACS messages to avoid messages returned from
server from being unable to reach their destination due to physical interface trouble. It is
recommended to use a Loopback interface address as the source IP address.
To Next Page
Loading...
Need help?
General