1-4
z Any aggregation group port you input in the destination port list will be removed from the list and the
copy command will not take effect on the port. If you want an aggregation group port to have the
same configuration with the source port, you can specify the aggregation group of the port as the
destination (with the destination-agg-id argument).
z Any voice-VLAN-enabled port you input in the destination port list will be removed from the list.
Example
# Duplicate the configuration of Ethernet 1/0/1 to Ethernet 1/0/2 and Ethernet 1/0/3 (Ethernet 1/0/3 is an
aggregation group member port).
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] copy configuration source ethernet 1/0/1 destination ethernet 1/0/2 ethernet 1/0/3
Note: The following will be removed from destination port list:
Aggregation port(s),Voice vlan port(s).
Copying VLAN configuration...
Copying Protocol based VLAN configuration...
Copying LACP configuration...
Copying QOS configuration...
Copying GARP configuration...
Copying STP configuration...
Copying speed/duplex configuration...
description
Syntax
description text
undo description
View
Ethernet port view
Parameter
text: Port description, a string of 1 to 80 characters.
Description
Use the description command to configure a description for the port.
Use the undo description command to remove the port description.
By default, no description is configured for a port.
You can use the display brief interface command to display the configured description.
Example
# Set description string "lanswitch-interface" for Ethernet 1/0/1.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] interface ethernet1/0/1
To Next Page
Loading...
Need help?
General