2-24
report-aggregation (MLD-Snooping view)
Syntax
report-aggregation
undo report-aggregation
View
MLD-Snooping view
Default Level
2: System level
Parameters
None
Description
Use the mld-snooping report-aggregation command to enable MLD report suppression.
Use the undo mld-snooping report-aggregation command to disable MLD report suppression.
By default, MLD report suppression is enabled.
This command works on MLD snooping–enabled VLANs.
Examples
# Disable MLD report suppression.
<Sysname> system-view
[Sysname] mld-snooping
[Sysname-mld-snooping] undo report-aggregation
reset mld-snooping group
Syntax
reset mld-snooping group { ipv6-group-address | all } [ vlan vlan-id ]
View
User view
Default Level
2: System level
Parameters
ipv6-group-address: Clears the information about the specified multicast group. The effective range of
ipv6-group-address is FFxy::/16 (excluding FFx0::/16, FFx1::/16, FFx2::/16 and FF0y::), where x and y
represent any hexadecimal number between 0 and F, inclusive.
all: Clears all MLD snooping multicast group information.
vlan vlan-id: Clears the MLD snooping multicast group information in the specified VLAN. The effective
range of vlan-id is 1 to 4094.
Description
Use the reset mld-snooping group command to clear MLD snooping multicast group information.
Note that:
To Next Page
Loading...
Need help?
General