2-2
Table 2-1 Description on the fields of the display fib command
Field Description
Flag
Flags:
U: A route is up and available.
G: Gateway route
H: Local host route
B: Blackhole route
D: Dynamic route
S: Static route
R: Rejected route
E: Multi-path equal-cost route
L: Route generated by ARP or ESIS
Destination/Mask Destination address/mask length
Nexthop Next hop address
TimeStamp Timestamp
Interface Forwarding interface
display fib ip-address
Syntax
display fib ip-address1 [ { mask1 | mask-length1 } [ ip-address2 { mask2 | mask-length2 } | longer ] |
longer ]
View
Any view
Parameters
ip-address1, ip-address2: Destination IP addresses, in dotted decimal notation. ip-address1 and
ip-address2 together define an address range. The FIB entries in this address range will be displayed.
mask1, mask2: Subnet masks, in dotted decimal notation.
mask-length1, mask-length2: Length of the subnet masks, the number of consecutive ones in the
masks, in the range of 0 to 32.
longer: Displays the FIB entries matching the specified address/mask and having masks longer than or
equal to the specified mask. If no masks are specified, FIB entries that match the natural network
address and have the masks longer than or equal to the natural mask will be displayed.
Description
Use the display fib ip-address command to view the FIB entries matching the specified destination IP
address.
If no mask or mask length is specified, the FIB entry that matches the destination IP address and has
the longest mask will be displayed; if the mask is specified, the FIB entry that exactly matches the
specified destination IP address and mask will be displayed.
To Next Page
Loading...
Need help?
General