1-10
port hybrid pvid vlan
Syntax
port hybrid pvid vlan vlan-id
undo port hybrid pvid
View
Ethernet port view
Parameters
vlan-id: Specifies the default VLAN ID of the current hybrid port, in the range of 1 to 4094. The specified
VLAN can be one already created or not.
Description
Use the port hybrid pvid vlan command to set the default VLAN ID of the hybrid port.
Use the undo port hybrid pvid command to restore the default VLAN ID of the hybrid port.
If the specified default VLAN has been removed or is not carried on the hybrid port, the port will be
unable to receive VLAN untagged packets. You can configure a hybrid port to permit the packets of its
default VLAN to pass through with the port hybrid vlan command.
Related commands: port link-type, port hybrid vlan.
The local and remote hybrid ports must use the same default VLAN ID for the traffic of the default VLAN
to be transmitted properly.
Examples
# Set the default VLAN ID of the hybrid port Ethernet 1/0/1 to 100.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] interface ethernet1/0/1
[Sysname-Ethernet1/0/1] port link-type hybrid
[Sysname-Ethernet1/0/1] port hybrid pvid vlan 100
port hybrid vlan
Syntax
port hybrid vlan vlan-id-list { tagged | untagged }
undo port hybrid vlan vlan-id-list
View
Ethernet port view
Parameters
vlan-id-list: List of the VLANs that the current hybrid port will be assigned to or removed from. In this list,
you can specify individual VLAN IDs (each in the form of vlan-id) and VLAN ID ranges (each in the form
To Next Page
Loading...
Need help?
General