1-1
1 ARP Configuration Commands
ARP Configuration Commands
arp check enable
Syntax
arp check enable
undo arp check enable
View
System view
Parameters
None
Description
Use the arp check enable command to enable the ARP entry checking function on a switch.
Use the undo arp check enable command to disable the ARP entry checking function.
With the ARP entry checking function enabled, the switch cannot learn any ARP entry with a multicast
MAC address. Configuring such a static ARP entry is not allowed either; otherwise, the system prompts
error information.
After the ARP entry checking function is disabled, the switch can learn the ARP entry with a multicast
MAC address, and you can also configure such a static ARP entry on the switch.
By default, the ARP entry checking function is enabled.
Examples
# Disable the ARP entry checking function.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] undo arp check enable
arp detection enable
Syntax
arp detection enable
undo arp detection enable
View
VLAN view
To Next Page
Loading...
Need help?
General