1-1
1 Stack Function Configuration Commands
Stack Function Configuration Commands
display stacking
Syntax
display stacking [ members ]
View
Any view
Parameter
members: Displays the information about the members of a stack. Do not specify this keyword when
you execute this command on a slave switch.
Description
Use the display stacking command to display the information about the main switch or the slave
switches of a stack.
When you execute this command on a main switch, the information displayed depends on the
members keyword as follows:
z If the members keyword is not specified, the output information indicates that the local switch is the
main switch. Besides, the number of the switches contained in the stack is also displayed.
z If the members keyword is specified, the information about the members of the stack is displayed,
including the stack numbers of the main/slave switches, stack name, stack device name, MAC
address and status.
When you execute this command on a slave switch, the information displayed indicates that the local
switch is a slave switch. Besides, the information such as the stack number of the local switch, and the
MAC address of the main switch in the stack is also displayed.
Example
# Display the information about a stack on the main switch.
<stack_0.Sysname>display stacking
Main device for stack.
Total members:3
Management-vlan:1(default vlan)
# Display the information about the stack members on the main switch.
<stack_0.Sysname> display stacking members
Member number: 0
Name:stack_0.Sysname
Device: S3100
To Next Page
Loading...
Need help?
General