1-6
execute
Syntax
execute filename
View
System view
Parameter
filename: Batch file, with the extension .bat.
Description
Use the execute command to execute the specified batch file. Executing a batch file is to execute a set
of commands in the batch file one by one.
Note that:
z A batch file cannot contain any invisible character. If any invisible character is found, the system
will abort the execution of the batch file, that is, the remaining commands in the batch file will not be
executed, but the executed operations will not be cancelled.
z Not every command in a batch file is sure to be executed. For example, if a certain command is not
correctly configured, the system omits this command and goes to the next one.
z Each configuration command in a batch file must be a standard configuration command, meaning
that the configuration information can be displayed with the display current-configuration
command after this command is configured successfully; otherwise, this command may not be
executed correctly.
Example
# Execute the batch file named test.bat under the directory flash:/.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] execute test.bat
<Sysname>
....
%Created dir unit1>flash:/test3.
file prompt
Syntax
file prompt { alert | quiet }
View
System view
Parameter
alert: Specifies to prompt for confirmation before performing file-related operations that have potential
risks.
quiet: Specifies to disable prompts for file-related operations.
Description
Use the file prompt command to configure the prompt mode for file-related operations.
To Next Page
Loading...
Need help?
General