2-1
2 Monitor Link Configuration Commands
Currently, only S3100-EI series Ethernet switches support the monitor link feature.
Monitor Link Configuration Commands
display monitor-link group
Syntax
display monitor-link group { group-id| all }
View
Any view
Parameter
group-id: Monitor Link group ID, ranging 1 to 24.
all: Specifies all the Monitor Link groups.
Description
Use the display monitor-link group command to display Monitor Link group information.
Example
# Display the information about Monitor Link group 1.
<Sysname> display monitor-link group 1
Monitor link group 1 information:
Member Role Status Last-up-time Last-down-time
----------------------------------------------------------------------
SMLK-2 UPLINK UP 16:37:20 2006/4/21 16:37:20 2006/4/20
AGG-1 DOWNLINK UP
Table 2-1 Description on the fields of the display monitor-link group command
Field Description
Member Member of the Monitor Link group
Role Role of Monitor Link group member port: UPLINK or DOWNLINK
Status Status of Monitor Link group member port: UP or DOWN
To Next Page
Loading...
Need help?
General