H3C S3100 Series

1-8
Parameter
group-id: Smart link group ID, in the range of 1 to 24.
Description
Use the smart-link group command to create a Smart Link group and enter Smart Link group view. If
the specified Smart Link group exists, this command leads you into Smart Link group view directly.
Use the undo smart-link group command to remove the specified Smart Link group.
After creating a Smart Link group, you must configure member ports for this Smart Link group.
Related command: port smart-link group, link-aggregation group, and port.
Make sure that the Smart Link group has no members before executing the undo smart-link group
command.
Example
# Create a Smart Link group.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] smart-link group 1
New Smart Link Group has been created.
[Sysname-smlk-group1]