1-32
reset traffic-statistic vlan
Syntax
reset traffic-statistic vlan vlan-id inbound acl-rule
View
System view
Parameter
vlan-id: VLAN ID, in the range 1 to 4094.
inbound: Specifies to clear the statistics on the inbound packets.
acl-rule: ACL rules to be applied. This argument can be the combination of multiple ACLs. For more
information about this argument, refer to
Table 1-9 and Table 1-10.
Description
Use the reset traffic-statistics vlan command to clear the statistics on packets that are of a VLAN and
match specific ACL rules.
Related command: traffic-statistic vlan.
Only H3C S3100-EI series switches support this command.
Example
# Clear the statistics on packets that match ACL 2000 and are of VLAN 1 (assuming that the current
device is an S3100-EI series switch).
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] reset traffic-statistic vlan 1 inbound ip-group 2000
traffic-limit
Syntax
traffic-limit inbound acl-rule target-rate [ burst-bucket burst-bucket-size ] [ conform con-action ]
[ exceed exceed-action ] [ meter-statistic ]
undo traffic-limit inbound acl-rule [ meter-statistic ]
View
System view, Ethernet port view, Port group view
Parameter
inbound: Performs traffic policing on the inbound packets.
To Next Page
Loading...
Need help?
General