1-33
acl-rule: ACL rules to be applied. This argument can be the combination of multiple ACLs. For more
information about this argument, refer to
Table 1-9 and Table 1-10. Note that the ACL rules referenced
must be those defined with the permit keyword specified.
target-rate: Target traffic rate of traffic policing ( in kbps). This argument is in the range of 64 to 1000000
in system view and port group view. In Ethernet port view, the range of this argument varies by port type
as follows:
z Fast Ethernet port: 64 to 99,968;
z GigabitEthernet port: 64 to 1,000,000.
The granularity of port rate limit is 64 Kbps. Assume that the value you provide for the target-rate
argument is in the range N*64 to (N+1)*64 (N is a natural number), it will be rounded off to (N+1)*64.
burst-bucket burst-bucket-size: Specifies the maximum burst traffic size (in kilobytes) allowed. The
burst-bucket-size argument must a multiple of 8 and ranges from 8 to 1016.
conform con-action: Sets the actions of the switch on the packets except forwarding when the packet
traffic is within the specified traffic. The con-action argument can be:
z remark-dscp dscp-value: Sets the DSCP precedence for the packets. The dscp-value argument is
in the range of 0 to 63. You can also enter a keyword listed in
Table 1-15 for this argument.
z remark-cos cos-value : Sets the 802.1p precedence for the packets. The cos-value argument is in
the range of 0 to 7. You can also enter a keyword listed in
Table 1-16 for this argument.
Table 1-15 DSCP precedence keywords and the corresponding decimal/binary values
Keyword DSCP value (decimal) DSCP value (binary)
af11
10 001010
af12
12 001100
af13
14 001110
af21
18 010010
af22
20 010100
af23
22 010110
af31
26 011010
af32
28 011100
af33
30 011110
af41
34 100010
af42
36 100100
af43
38 100110
be (the default) 0 000000
cs1
8 001000
cs2
16 010000
cs3
24 011000
cs4
32 100000
cs5
40 101000
cs6
48 110000
To Next Page
Loading...
Need help?
General