1-7
View
Ethernet port view/system view
Parameter
vlan-id: Control VLAN ID, in the range of 1 to 4,094.
Description
Use the smart-link flush enable control-vlan command to enable the current/specified port to
process flush messages received on the specified control VLAN.
Use the undo smart-link flush enable command to disable the port from processing flush messages.
z The command executed in Ethernet port view has effect on the current port only.
z The command executed in system view has effect on the specified port only.
By default, no control VLAN is specified.
If you configure different control VLANs on the same port, only the last one takes effect.
The VLAN configured as a control VLAN for sending or receiving flush messages must exist. You
cannot directly remove the control VLAN. When a dynamic VLAN is configured as a control VLAN for
the Smart Link group, this VLAN will become a static VLAN, and related prompt information is
displayed.
Example
# Enable Ethernet1/0/4 to process flush messages received from control VLAN 1..
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] interface Ethernet 1/0/4
[Sysname-Ethernet1/0/4] smart-link flush enable control-vlan 1
# Enable Ethernet1/0/5 through Ethernet1/0/10 to process flush messages received from control VLAN
1.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] smart-link flush enable control-vlan 1 port Ethernet 1/0/5 to Ethernet 1/0/10
smart-link group
Syntax
smart-link group group-id
undo smart-link group group-id
View
System view
To Next Page
Loading...
Need help?
General